Ready-Strip
  • Readystrip Color Change feature signals when the job is done
  • Safer Stripper is READY to remove when it turns off-white
  • Unique Stripper is capable of removing 3-5 layers in a single application
  • Biodegradable
  • User Friendly
  • Odorless
  • Safe to Use
  • Non-flammable
  • Non-combustible
  • Easily cleaned up with water
  • Contains NO methylene chloride, caustic or harsh chemicals
  • Removes 2-3X more paint than conventional liquid strippers
  • No drip formula clings to vertical surfaces and completely fills detailed areas
  • Eliminates Guesswork - Removes most varieties of household paints, varnishes, latex, alkyds, stains, enamels, lacquers, and polyurethanes
  • Use on interior or exterior surfaces including wood, plaster, concrete, brick, stone, masonry, marble, metal and veneers (DO NOT use on sheetrock, plastic, rubber or linoleum surfaces)

BACK TO NATURE PRODUCTS CO.
ENGLISHTOWN, NJ 07726
 732-792-2001


Application and Removal:  Mask any areas not being stripped with plastic and masking tape.  Apply Ready-Strip liberally to the surface with a brush, medium sized nap paint roller, or putty knife so that the remover completely masks or covers the color of the surface to be stripped.  Do not brush out too thin like a coat of paint.  It covers approximately 50 square feet per gallon.  Apply at temperatures between 60°F and 80°F.  When the stripper turns off-white or a pale green, it may form an eggshell like skin to lock in the stripping action.  Misting the area to be removed with water or After-Strip Paint Remover Wash prior to actual removal will soften the skin and make lifting of the paint or varnish easier.   After the stripper has turned off-white or a pale green, use a stiff putty knife to lift paint from flat surfaces or a stiff bristle brush for detailed areas.  After initial lifting, use a nylon bristle brush or stripping pad to scrub surface.  The time the stripper takes to turn off-white or pale green may vary depending upon the type and amount of paint, the surface and temperature.  Typical color change occurs within 4-24 hours.  Paint and varnish removal may take place prior to the Color Change, although the Color Change will indicate the end of stripping action.
 

TEST PATCH:  Since it is often hard to know the type or the amount of paint or varnish on a surface, a small area should be tested first to determine whether the desired results will be achieved.
 

Apply After-Strip Paint Remover Wash or light amounts of water for final clean up to residue.  Surface should be completely dry before repainting.  No need to neutralize (acid wash) surface.  Clean tools promptly after use with soap and water.
 

REMOVAL TIME:  On interior surfaces, the softened paint/varnish may remain moist under the eggshell skin for several days for easy removal.  On exterior surfaces, due to the potential for higher temperatures and direct sunlight, the color Change may be greatly accelerated (f1-8 hours).  The paint should be removed shortly after Color Change to prevent the stripper from drying out.  Not advisable for outdoor decks.
 

HINTS:  If Ready-Strip is applied too thinly, left on too long, or due to excessive heat conditions, the applied area is difficult to scrape, try the following: 1) Mist the applied area with water or After-Strip, wait 5-15 minutes and remove; 2) Reapply Ready-Strip over itself, wait 15-30 minutes and remove; 3) if 1) or 2) does not work, scrape off and reapply.  If product freezes in bucket, let thaw and stir vigorously until product is consistent.
 

INGREDIENTS:  Dimethyl Glutarate (1119-40-0), Dimethyl Adipate (627-93-0), N Methyl- 2 Pyrrolidone (872-50-4), Water (7732-18-5), Magnesium Aluminum Silicate (12174-11-7)  Product # RS01  VOS - .9 lbs. per gallon, VOC - 100 grams per liter.
 

KEEP OUT OF REACH OF CHILDREN
CAUTION:  May cause eye and skin irritation on contact
Close container tightly after each use.  Do not take internally.
NOTICE:  Provide adequate ventilation in confined areas.
 

SAFETY & FIRST AID:  Rubber gloves and safety glasses are recommended for eye and skin protection.  Avoid eye contact.  If eye contact occurs, immediately flush with plenty of water for 15 minutes.  Avoid prolonged and repeated contact with skin.  If skin contact occurs, wash with soap and water.  If spraying is expected use NIOSH approved chemical cartridge respirator.  If swallowed do not induce vomiting.  Give 1 or 2 glasses of water and call a physician immediately.
 

LIMITED WARRANTY:  This product is warranted such that it will be free from defects in material or workmanship and purchasers sole remedy is replacement of defective product.  This warranty is made in lieu of any other warranties, expressed or implied, including warranties of merchantability or fitness.  Company shall not be liable for any loss, damage, or injury, direct, consequential, or incidental from use of product.  The purchaser shall be responsible for determining suitability of the product for his/her intended use.

Purchase Back to Nature Products