Multi-Strip

BACK TO NATURE PRODUCTS CO.
 ENGLISHTOWN, NJ  07726
732-792-2001
 
  • MULTI-STRIP will safely remove up to 15 layers of paint or varnish in a single application
  • Environmental Friendly Stripper stays wet for extended periods of time to penetrate and lift multiple layers
  • Biodegradable
  • User friendly
  • Odorless
  • Safe to use
  • Non-flammable
  • Non-combustible
  • Easily cleaned up with water
  • Contains NO methylene chloride, caustic or harsh chemicals
  • No drip formula clings to vertical surfaces and completely fills detailed areas
  • Removes most varieties of household paints, varnishes, latex, alkyds, stains, enamels, lacquers, clear paints as well as more difficult coatings such as epoxy and urethanes
  • Use on interior or exterior surfaces including wood, plaster, concrete, brick, stone, masonry, marble, metal and veneers (DO NOT use on sheetrock, plastic, rubber or linoleum surfaces)

Application and Removal:  Mask any areas not being stripped with plastic and masking tape.  For best results apply at temperatures between 60°F and 80°F.  Apply MULTI-STRIP liberally to the surface with a brush, 1/2in nap paint roller, or putty knife so that the remover completely covers the color of the surface to be stripped (30 mils thick).  Do not brush out too thin like a coat of paint.  It covers approximately 50-75 square feet per gallon.  Check applied area at 2-4 hours, then periodically thereafter.  As a rule of thumb, the greater the layers of paint, the longer the product should be left on.  The stripper will usually remove 8-12 layers of paint in 24 hours.  More layers of paint (20+) may take longer (2-3+days).  Use a stiff putty knife to lift paint from flat surfaces or a stiff bristle brush for detailed areas.  After initial lifting, use a nylon brush or stripping pad with AFTER-STRIP Paint Remover Wash or light amounts of water to remove any residue.  Final clean-up should be done with water.  No need to neutralize (acid wash) surface.  Surface should be completely dry before repainting.  Clean tool promptly after use with soap and water.
 

TEST PATCH:  Since it is often hard to know the type or the amount of paint or varnish on a surface, a small area should be tested first to determine whether the desired results will be achieved, and if so it will determine time of removal.
 

In some situations where there are newer latex paints on top of oil paints, the top coats may soften easily causing the surface to pull away (usually in 2-6 hours).  If this occurs, scrape off paint and reapply immediately, if necessary to penetrate bottom layers.  A thinner coat is all that is needed to remove the latex.  Follow with a thicker coat.
 

HINTS:  Let the stripper do the work for you.  Give it the proper time to penetrate the paint layers or you defeat its purpose.  Misting the area to be removed with water prior to removal may make lifting of the paint or varnish easier.  If desired results are not achieved at first, leave stripper on longer if still wet, or apply a thicker coat.  If still tacky and moist, reapply stripper over itself.  If completely dry, scrape off and reapply.  Product activity is reduced below a temperature of 60°F and may require additional dwell time before all layers of paint are removed.
 

INGREDIENTS:  Dimethyl Glutarate (1119-40-0), Dimethyl Adipate (627-93-0), N Methyl- 2 Pyrrolidone (872-50-4), Proprietary Filler (NA), Magnesium Aluminum Silicate (12174-11-7)  Product # MS01  VOS - .9 lbs. per gallon, VOC - 100 grams per liter.

 

KEEP OUT OF REACH OF CHILDREN
 CAUTION:  May cause eye and skin irritation on contact
Close container tightly after each use.  Do not take internally.
NOTICE:  Provide adequate ventilation in confined areas.

 

SAFETY & FIRST AID:  Rubber gloves and safety glasses are recommended for eye and skin protection.  Avoid eye contact.  If eye contact occurs, immediately flush with plenty of water for 15 minutes.  Avoid prolonged and repeated contact with skin.  If skin contact occurs, wash with soap and water.  If spraying is expected use NIOSH approved chemical cartridge respirator.  If swallowed do not induce vomiting.  Give 1 or 2 glasses of water and call a physician immediately.
 

LIMITED WARRANTY:  This product is warranted such that it will be free from defects in material or workmanship and purchasers sole remedy is replacement of defective product.  This warranty is made in lieu of any other warranties, expressed or implied, including warranties of merchantability or fitness.  Company shall not be liable for any loss, damage, or injury, direct, consequential, or incidental from use of product.  The purchaser shall be responsible for determining suitability of the product for his/her intended use.

Purchase Back to Nature Products