|
 |
|
|
Before Using - Read Entire Label |
|
DEFY Masonry
Crack & Joint Sealant is a brushable elastomeric sealant
for brick and mortar joints used to repair exterior cracks in mortar on
chimneys, brick walls and between concrete or stone masonry units.
The product seals larger cracks and other defects that cannot be corrected
with water repellents alone. Product seals cracks up to 1/8in wide
on brick faces and at mortar and brick joint interfaces to provide
waterproof protection. It dries clear to milky white, depending on the size of the crack.
DEFY Sealant prevents water infiltration and subsequent damage, yet allow
water vapor to escape. When applied to a properly prepared wall or
chimney surface, DEFY Sealant can solve tough leak problems without the
expense of tuckpointing or surface grouting. Product will not
significantly change the appearance of most walls, chimneys or masonry
surfaces. A slight gloss will occur on dense surfaces.
Testing is recommended before treating any surface to ensure desired
results.
DIRECTIONS FOR USE
Surface Preparation: Carefully prepare surface by repairing any
loose or missing mortar joints or brick faces. Remove all dirt,
dust, and moss growth prior to application of DEFY Sealant. For
maximum water repellent protection apply a DEFY masonry water repellent
prior to the application of product. Allow solvent based
formulations to dry completely. DEFY Sealant can be applied to
surfaces still damp from application of DEFY water-based water repellent.
Application: Mix thoroughly; do not thin. Brush horizontal
bed joints with DEFY Sealant using the 4 inch wide brush. Then apply
product to head joints using smaller 1 inch wide head-joint brush.
Fill all cracks and voids thoroughly. After a few minutes smooth
excess areas with a clean brush or rag to prevent product build-up on
brick faces. Apply DEFY Sealant only when existing temperatures
exceed 40°F. Avoid getting
product on non-targeted surfaces.
Clean Up: Remove any excess or spills with clean rags or soap and
water before DEFY Sealant cures. Wash brushes and equipment with
warm soapy water and rinse thoroughly.
|
KEEP FROM
FREEZING
|
Coverage Rates:
A half-gallon container of DEFY Sealant will treat the mortar joints
surrounding approximately 550 standard size bricks, or approximately 100
square feet of wall surface. Actual coverage rates will vary with
the size of masonry units, the degree of damage, and the width and
porosity of the mortar joints.
CAUTIONS
Keep from children. Protect from freezing. Keep container
closed. Respiratory protection is not generally required during
normal use and handling. The use of protective gloves and chemical
splash goggles is recommended. Wash thoroughly after handling.
Do not take internally. If swallowed, call a physician. For
eye contact, flush with water for 15 minutes and get prompt medical
attention if necessary. For skin contact, wash with soap and water.
Refer to MSDS for specific information. |
| Maximum V.O.C content |
0.36 lbs/gal (43 gr/lt) |
LIMITED WARRANTY
Our recommendations for use of this product are based upon testing
believed to be reliable. Since field conditions vary widely, the user must
determine the suitability of the product for the particular use and
specific method(s) of application. Due to the fact that SaverSystems
has no control over surface preparation and application methods, no
guarantee as to results is offered, expressed, or implied.
SaverSystems only warrants the contents of the container. If the
product is defective, a refund of the material cost or replacement
material will be provided at the manufacturers option. This warranty
does not include labor or cost of labor for the application of DEFY
Sealant. SaverSystems shall not be liable for incidental or
consequential damages resulting from any breach of the warranty and
fitness for use. Some states do not allow the exclusion of
incidental or consequential damages, so the above exclusions may not apply
to you. This warranty gives you specific legal rights. You may
also have other rights which vary from state to state.
MADE IN USA
SaverSystems
Richmond, IN 47374
www.saversystems.com
|
|
|
purchase Masonry Crack & Joint Sealant |
|
|