|
This high quality
WATER BORNE
product can be
used in areas of
hard usage such
as hallways,
entranceways,
even kitchens and
baths. It dries
to a hard, dead
flat finish yet
is easy to remove
dirt and grime
with a simple
washing.
Absolutely the
best flat paint
you can buy!
Use- Interior
wood, drywall,
wallboard, metal
panels, plaster
and masonry
surfaces.
Material
Preparation- Stir
thoroughly
before and
occasionally
during use.
Thinning- None
required for
brushing, rolling
or airless spray.
Use a .017 tip
for airless. If
thinning is
required for
conventional or HVLP spray, thin
with 10-15% water
only. Note:
Certain paint
additives may be
detrimental to
the performance
of this product.
Coverage- Up to
400 sq. ft. per
gallon depending
on porosity and
roughness of
substrata.
Tinting- Use
universal tinting
colors.
Surface
Preparation-
Surfaces must be
clean and free
from dirt, grease
and oil. Glossy
surfaces must be
dulled with
sandpaper. Patch
holes and cracks
with patching
compound and
prime repaired
areas. Reset
popped drywall
nails, fill with
patching compound
and prime.
Primer
requirements- No
primer needed for
previously
painted surfaces.
Use a quality
acrylic stain
blocking primer
to cover stained
areas. Over new
wood, drywall or
plaster, use an
acrylic universal
primer. For metal
an acrylic
corrosion
resistant primer
is recommended.
Previously
painted metal in
good condition
does not require
a primer.
Application-
Apply by brush,
roller or spray.
Mix together
separate
containers of
paint to assure
uniform color. If
unable to do so,
make sure new
cans of paint are
started at a
natural stopping
point such as a
corner. Cut in
the edges of the
walls with a
brush first.
Apply an even
coat with a
roller by rolling
a large “W” on
the wall. Then
roll to spread
the paint. Keep
brush and roller
filled with
paint. Do not
roll or brush
excessively:
allow the paint
to level out. Do
not paint below
50°F.
Dry Time- Dry to
touch in one half
hour. For best
results, allow to
dry 4 hours
before recoating.
Note: There will
be a noticeable
slight sheen
initially when
the paint dries.
It will usually
take several days
for the finish to
achieve it’s
final flatness.
Cleanup-
Immediately clean
up spills and
equipment with
detergent and
water.
|
