|
DESCRIPTION: After-Strip Paint Remover Wash gently removes
the residue and softened layers sometimes remaining after paint or varnish
removal. This water-based solution contins no methylene chloride, is
non-flammable, and easy to sue. It works on interior and exterior
surfaces including wood, plaster, concrete, brick stone, metal marble,
fiberglass, veneers, etc... (Do not use on sheetrock, plastic,
rubber or liinoleum surfaces.)
DIRECTIONS FOR USE:
1. Use immediately after paint or varnish removal.
2. If bottom layers appear intact, or surface is very tacky or gummy,
then there is paint or varnish remaining on the surface. Therefore, reuse
Back to Nature Paint & Varnish Removers as directed before applying
After-Strip Paint Remover Wash.
3. Apply After-Strip Paint Remover Wash liberally onto the surface.
Allow After-Strip to stay on the surface approximately 1-2 minutes.
4. Use a cloth, stripping pad or nylon brush to scrub surface with
After-Strip Paint Remover Wash. On wood, rub back and forth along the
grain of the wood.
5. Use a second application where necessary.
6. After surface is clean, wipe down with a dry cloth and let dry a
minimum of 24 hours. Surface should be completely dry before refinishing.
7. If after using After-Strip Paint Remover Wash, stubborn paint or
varnish remains on the surface, reuse Back to Nature Paint & Varnish
Remover and repeat application of After-Strip where necessary.
SAFETY INSTRUCTIONS: Due to the sensitive nature of certain person’s
skin and eyes, chemical resistant gloves and safety glasses are
recommended. Avoid eye contact. If eye contact occurs immediately flush
with water for 15 minutes. Avoid prolonged and repeated contact with skin.
If skin contact occurs, wash with soap and water. Do not take internally.
If swallowed do not induce vomiting. Give 1 or 2 glasses of water and call
a physician immediately. |
